How to install the felt mat on an automatic feeding cutting machine
Introduction of felt mat installation
on an automatic feeding cutting machine
Felt
installation steps:
1.
Adjust the conveying roller to
reduce the distance between the two rollers, wrap the felt around the conveying
roller, and put the joint on the upper surface of the vacuum adsorption
platform.
2.
Place Teflon high temperature
resistant cloth under the felt joint to prevent the glue from sticking to the
platform when ironing. Use a brush to evenly apply the glue to the two joints.
3.
After the glue is applied, the
two felt ends are needed to be butted and flattened.
4.
Apply a piece of Teflon cloth
to the surface of the glued joint and prepare to iron.
5.
Use an industrial iron to iron
when the temperature reaches 120 degrees Celsius.
6.
After 20 minutes, after the
glue has dried, use the same method to stick the 4 pieces of wrap cloth to the
ends of the joint as shown in the figure. The length of the wrap cloth is
preferably longer than the presser foot on the beam. Its length is about 12 cm.
Try not to let the presser foot press on the joint.
7.
After ten minutes, after the
glue has dried, remove the Teflon cloth on the upper surface of the joint, rotate
the roller by hand, move the joint to the roller, check the joint at the bend,
and apply glue on the gap. Then, rotate the roller, move the joint to the upper
surface of the platform, spread the Teflon cloth, and flatten the newly applied
glue.
8.
A few hours later, after the
glue is completely dry, adjust the distance between the two rollers to the
working state. Then, the machine can be started normally.
Description
of materials needed:
Made by Max
Max Chen
Telephone/WeChat/Skype/WhatsApp:
+8615989311679
Email: reliablelaser.max@hotmail.com
Shenzhen, China
